Tile & Grout Cleaning in St. John, In.

Tile and Grout Cleaning in St. John, In.| Great White tile and Grout Cleaning

image

Grout is a mixture of cement, color, and sand. It is porous and, as a result, grout easily absorbs grease, dirt and lime scale. Floor manufacturers recommend that you have your tile and grout cleaned in Munster, In. once every 12 to 18 months because regular mopping just doesn't reach the stubborn dirt that lies deep in the pores of your grout lines, but our high-pressure cleaning process does.

 

Microscopic pores in the grout allow dirt and other contaminants to become trapped below the surface, where it can't be removed by regular mopping and cleaning. This is why it's so important to hire an experienced professional to clean your tile and grout in St. John, In on a regular basis, so call Great White Hard Surface Specialists.  We specialize in cleaning your tile and grout and restoring it to near new appearance.

 

We use the most highly recommended process to clean tile grout in St. John, In.: a steam extraction method involving extremely hot water, detergents, water pressure and vacuum extraction. Steam extraction machines dislodge dirt packed in the tiny holes in your grout lines and lift it out. Great White uses truck mounted cleaning machines that power washes the floor to extract soil and grease from the pores of the tile and grout or other hard surface floors. The system that our professional Certified Technicians, Tile and grout cleaners use generates water pressure of 1,000 to 1,200 PSI and a water temperature of approximately 240 degrees to soften and extract years of soil and contaminants. The vacuum hose draws away the water, along with the dirt, to a containment tank on our truck and we dispose of the waste in accordance with Environmental Protection Agency (EPA) regulations.

 

Our tile and grout cleaning process in St. John, In. restores the tile and grout to 85 to 90 percent of its original appearance. Most stains are removed, but some stains like red wine, mustard and dyes will not come out because they permanently dye the grout. For situations like this, our Tile and Grout Cleaning experts recommend restoring your grout with a pigmented penetrative seal to give grout lines a fresh new look and save you the expense of re-grouting. This latex-based topical sealer is applied to your grout lines, once your tile flooring has been properly cleaned and dried.

 

Please note, after your floor is cleaned in St. John, In. and the seal is applied, Great White recommends that you wait 30 minutes before walking on the floor to allow the sealant to dry. It will take 24 hours for the sealant to cure completely, so please avoid any liquid coming in contact with the sealant during that time.

 

Call Us Today: 219.690.1287

 

 

 

Even if your grout isn't currently discolored, it pays to protect your grout lines and keep them looking good. Regular application of our sealant will keep stains beaded up on the surface of your grout lines to give you enough time to wipe up dirt and spills before they are absorbed. Absorbed stains could permanently discolor your grout, and ground in dirt could cause your grout to weaken and break down. Protect your grout. Ask us to apply a solvent base clear or color sealant each time we come out to clean your tile and grout.

 

Great White Hard Surface Specialists IS YOUR FIRST AND LAST CALL FOR…Natural stone honing, polishing and sealing, Floor Stripping and Waxing ,No-Sand Wood Floor Refinishing , Tile and Grout Cleaning and Stainless steel Scratch Removal and Polishing Call Today 219.690.1287